Ironman Visor Servo and Eye Light Controller Board
The servo board will allow you to motorize the face and jaw of your ironman mask. It will also control an external (optional) light array for the eyes.
The servo controller board comes standard with a pushbutton to command the
servo motors: Press it once and the jaw will open first, followed by the visor. The eye lights will automatically go out.. Press it again
and the visor will close first, followed by the jaw. The eyes will go on.
The delay between the jaw and visor activation is also programmable between 20ms - 1 sec. The light driver circuit can handle up to 600mA of current or 1.5A with a simple upgrade.
Click image to enlarge |
 |
Movie of Servo Controller
Click HERE to see a movie of the visor board in action!
Servo Controller Specifications
- Small size: 1" x 1"
- Runs off 6-12V battery
- Controls any off the shelf servo
- Is compatible with any LED light array (external resistor needed)
* A servo is a DC motor that can be positioned accurately by sending
it commands. A servo motor typically travels over a 90 degree
span, and the speed of the servo motor can be controlled. These
are commonly used in R/C cars, boats, planes, etc. You can
purchase standard servo motors online at www.towerhobbies.com
Related or Recommended Kits
Ironman Arc Reactor
Vortex 2 Sound Effects Amp (w/ Ironman Effect)
Instruction Manual download
Kit Pricing
Ironman Visor and Eye Controller Board (requires eye light array and resistor- not included) |
|
|
|